Stick on Patches – 0.6g to 2.6g
Add a mitten hook, loop or pair of buckles to your DCF tent, tarp, groundsheet or anything else made from DCF. Great for hanging up your socks and gloves to dry, anchoring your lantern, or adding a clip to the interior of your DCF pack.
We use polyester webbing and 1.43oz DCF with 3M reaction adhesive to form a structural bond with DCF. These patches will also stick to Thermarest fabric, but will not stick to silicon coated fabrics.
Sold in pairs, use the drop down to select from the available tie-outs:
- Loop only – 0.6g each
- Mitten hook – 1.5g each
- Buckle pair – 2.6g
Specification
- 2" square of 1.43oz DCF
- Tough polyester webbing
- 3M reaction adhesive for a permanent structural bond on DCF
Loadbearing: These are light-duty, for lanterns etc. If you need full-strength tie-outs, see my adhesive tie-outs.
Instructions
Be sure to stick this to the shiny side of your DCF gear. For 2.92oz and 5oz DCF, this will usually be inside (the rough outside is polyester).
- Make sure the area where the tie-out is to be applied is clean and dry
- Peel off the backing paper
- Stick on the patch and press firmly to create a strong seal
Your problem is solved!
If possible, leave the patches resting with weight pressing down on flat surface for up to 16 hours to achieve maximum bond strength.